Views: 0 Author: Site Editor Publish Time: 2023-08-08 Origin: Site
Focusing on the field of intelligent transportation, LED Strobe Lights are developed for various capture systems and are used as fill light for high-definition digital camera capture. It is a new type of high-power and high-performance digital LED Strobe Light developed to meet the working environment and functional requirements of electronic police such as security checkpoints, speeding snapshots, and running red lights.
What should be considered before LED Strobe Light installation?
What is the actual use value of LED Strobe Light?
What is the wiring method of the LED Strobe Light?
Visually inspect the appearance of lamp cups, lampshades, and lamp holders for scratches, burrs, cracks, deformations, and other undesirable phenomena. Take a set of samples for trial assembly to confirm whether the size and position of the screw holes of each accessory are appropriate. Visually check whether the circuit board and the polarity of the components are clearly marked; whether the copper foil is bulging; use a multimeter to test whether the circuit (aluminum substrate) has open circuit or short circuit.
LED Strobe Light is specially developed for the working environment and functional requirements of the public security bayonet (HD, SD), using a unique digital control circuit to achieve high-energy light in a very short time, making the flash light and camera exposure time to achieve the most perfect Combined, to meet the requirements of the auxiliary camera system to take the clearest pictures of the vehicle and the driver under various light conditions, and minimize the interference and impact on the driver and surrounding residents.
1. The power supply is covered with a heat-shrinkable tube and heated to shrink it. Use a 20mm heat-shrinkable tube to cover the power supply, and heat it with a heat gun to shrink it. The length of the heat shrink tube must exceed the length of the power supply by about 1cm to 2cm.
2. Fix the lamp cap, put a small amount of 189 glue on the thread of the lamp cup, and tighten the lamp cap along the thread of the lamp cup that has been glued with 189 glue.
3. Apply thermal conductive silicone grease on the lamp cup, and evenly apply thermal conductive silicone grease on the plane of the lamp cup.
4. Fix the lamp board, weld the power output lead, stick the circuit board on the bottom plate where the lamp cup is fixed, fix the aluminum base plate with 3 screws, and pass the power output lead through the hole of the circuit board.
Guangzhou Wincode Optronics Co., Limited are running our own brand "Wincode Optronics" in the global market for lighting. Our products are suitable for various entertainment and recreation place, such as theatre, TV showroom, multimedia hall, square show, organ hall, recreational city, Disco club, Bar, KTV and so on.
